Before any check
Photograph Foundation-edge and below-grade entry, record the trigger and preserve the original condition. Confirm that access is safe and that the check will not disturb electrical equipment, hazardous materials, structural support or contaminated water.
Check the trigger
Repeat only one ordinary operating or weather-linked variable where safe. For this facet, the useful question is whether How repeated exterior loading can appear at wall, slab, joint or service penetrations after a lag. changes in a predictable way when that variable changes.
Check the route
Inspect accessible transitions through gutter, downspout, roof edge, patio, driveway, grade or foundation perimeter without cutting, drilling, removing guards or opening energized or regulated assemblies. Note both positive clues and intact boundaries.
Use a reference condition
Compare an unaffected room, component, time period or weather event using the same method. A control prevents normal variation from being mistaken for evidence of failure.
Record the result so it can be repeated
- Observe runoff during a safe rain event
- Map where each downspout discharges
- Compare ponding duration and interior symptoms after similar storms
- Use the same camera position, scale and measurement location.
- Write down what would count as no change before beginning the check.
Stop boundary
Avoid ladders, roofs, flooded electrical areas, unstable excavations and changes that direct water onto neighboring property. Significant foundation movement needs qualified review. The source set for this guide includes 4 official records selected for this path. They provide general technical and safety context; they do not determine the condition of a particular house.
Primary references for this topic family
These references ground the general building-science or safety context. They do not diagnose a specific house, replace local requirements or certify a repair.
